2″ 50 52 55mm Waste Pipe Joiner 45 Degree Elbow Compression Multifit

50mm 52mm 55mm Waste Pipe Joiner Coupling 45 degree Elbow 2″

Simple ‘nut & cone’ washer connection

No tools needed

Will join 50mm to 55mm waste pipe at a 45° (135°) angle

Perfect for joining bath, kitchen sink, shower tray, wet room, washing machine & dishwasher waste pipes that require the larger 2″ waste pipes (range 50-55mm)

For various waste pipes such as plastic push fit, plastic solvent weld, iron or copper etc… with the same outside diameters

Instructions:

Simply slide the white nut over the pipe first, then the red/orange/white nylon washer before the pointed black rubber washer

Make sure that the black rubber washer is pointing the thin end towards the white fitting you have yet to put on and slide the rubber on an inch or so

Push the rest of the fitting on so that the rubber joins up with the plastic fitting, you may then try and push the fitting with the rubber further down the pipe if need be

Finally bring the nut back and screw onto the rest of the fitting, compressing the pointed washer against the plastic to make a seal, then repeat the action for the other side and that’s it!