50 52 55mm To 40 42 43mm Waste Pipe Joiner Coupling Compression Multifit

50 52 55mm To 40 42 43mm Waste Pipe Joiner Coupling Compression Multifit

THIS ITEM IS MADE UP OF TWO SEPARATE FITTINGS

• Simple ‘nut & cone’ washer connection
• No tools needed
• Will join 40mm to 43mm and anything in between one end
• Will join 50mm to 55mm and anything in between the other end
• Perfect for joining bath, kitchen sink, shower tray, wet room, washing machine & dishwasher waste pipes to 2″ waste pipes (range 50-55mm)
• For various waste pipes such as plastic push fit, plastic solvent weld, iron or copper etc…

PLEASE NOTE FOR THE 2″ END: For thicker waste pipes, such as iron or smaller diameter pipes the plastic insert may have to be carefully cut out in order to install

Instructions:

1. Slide the white nut over the pipe first, then the red/orange/white nylon washer before the pointed black rubber washer
2. Make sure that the black rubber washer is pointing the thin end towards the white fitting you have yet to put on and slide the rubber on an inch or so
3. Push the rest of the fitting on so that the rubber joins up with the plastic fitting, you may then try and push the fitting with the rubber further down the pipe if need be
4. Finally bring the nut back and screw onto the rest of the fitting, compressing the pointed washer against the plastic to make a seal, then repeat the action for the other side and that’s it!

Brand:

• McAlpine

MPN(s):

• Z28M
• ZT26L