40mm to 43mm Multifit 90-Degree Plain End Trap Outlet Connector (1.5″)

40mm to 43mm Multifit 90-Degree Plain End Trap Outlet Connector (1.5″)

Features

This 40mm to 43mm multifit 90-degree plain end trap outlet connector provides a reliable, space-saving plumbing solution designed to connect directly onto a standard 1.5″ bath, shower, or kitchen sink trap outlet. Engineered with a flexible multifit compression mechanism on one end and a plain spigot connection on the other, this 90-degree fitting accommodates outside diameters ranging from 40mm to 43mm—making it fully compatible with plastic push-fit, solvent weld, copper, and lead pipes. Furthermore, the compact design allows you to tightly re-route your waste pipe at a sharp right angle immediately from the trap. As a result, you minimize joints, save valuable space in cramped under-sink or bath panel cupboards, and achieve a completely watertight directional change.

• Direct Trap Outlet Connection: Designed to attach directly onto the 40mm outlet of a bath, shower, or kitchen sink trap. Therefore, it eliminates extra intermediate couplings and streamlines your plumbing layout.
• Space-Saving 90-Degree Bend: Features a sharp right-angle elbow profile to tightly re-route waste lines. Consequently, it solves complex spatial constraints in tight vanity units, bath panels, and congested under-sink cupboards.
• Multifit Universal Compatibility: Engineered to bridge pipes measuring 40mm to 43mm in outside diameter. Moreover, it seamlessly connects varying pipe types including plastic, copper, and lead.
• Reduced Joint Count: Allows for fewer connections in your drainage run. As a result, it significantly lowers the risk of potential leak points and enhances overall system reliability.
• Durable Polypropylene Build: Constructed from high-quality, high-grade polypropylene. Furthermore, it withstands daily hot water flow and household chemicals to ensure long-lasting performance.

Technical

• Brand: VIVA
• MPN: W40D
• Product Type: 90-Degree Plain End Trap Outlet Connector
• Pipe Size Compatibility: 40mm to 43mm Outside Diameter (Standard 1.5″ Waste)
• Bend Angle: 90 Degrees
• Material Compatibility: Plastic Push-Fit, Solvent Weld, Copper, and Lead Pipes
• Connection Type: Compression x Plain End Trap Spigot
• Material: High-Quality Polypropylene
• Application: Direct-to-Trap 1.5″ Waste Pipe Re-routing for Baths, Showers, and Kitchen Sinks

Details

Installing a waste trap on a bath, shower tray, or kitchen sink often leaves very little clearance for routing discharge pipes straight out to the wall. Moreover, stringing together multiple separate connectors and elbows can create a bulky, leak-prone assembly in confined spaces.

Fortunately, this 40mm to 43mm multifit 90-degree plain end trap connector solves the problem with high-efficiency engineering. Because it connects directly onto the 40mm trap outlet and turns at a sharp right angle without needing extra intermediate fittings, it makes tight space management effortless. Consequently, you achieve a cleaner, more compact, and completely watertight drainage setup with fewer potential failure points.

Instructions

1. Simply slide the white nut over the pipe first along with the nylon washer, before the pointed black rubber washer
2. Make sure that the black rubber washer is pointing the thin end towards the white fitting you have yet to put on and slide the rubber on an inch or so
3. Push the rest of the fitting on so that the rubber joins up with the plastic fitting, you may then try and push the fitting with the rubber further down the pipe if need be
4. Finally bring the nut back and screw onto the rest of the fitting, compressing the pointed washer against the plastic to make a seal, then repeat the action for the other side and that’s it!

Discover

Explore Our Full Range of 40mm Compression Fittings – CLICK HERE