McAlpine MZ4 90° Elbow Bend – 2″ Compression Multifit Drain Connector

McAlpine MZ4 90° Elbow Bend – 2″ Compression Multifit Drain Connector

Ideal for urinal connections where constant maintenance are key

• Simple ‘nut & cone’ washer connection
• No tools needed
• Will join 50mm to 55mm and anything in between
• Perfect for bath, kitchen sink, shower tray, wet room, washing machine & dishwasher waste pipes needing an increased diameter
• For various waste pipes such as plastic push fit, plastic solvent weld, iron or copper etc… with the same outside diameters

For thicker waste pipes such as iron or smaller diameter pipes the plastic insert may have to be carefully cut out in order to install

Instructions:

1. Simply slide the white nut over the pipe first along with the nylon washer, before the pointed black rubber washer
2. Make sure that the black rubber washer is pointing the thin end towards the white fitting you have yet to put on and slide the rubber on an inch or so
3. Push the rest of the fitting on so that the rubber joins up with the plastic fitting, you may then try and push the fitting with the rubber further down the pipe if need be
4. Finally bring the nut back and screw onto the rest of the fitting, compressing the pointed washer against the plastic to make a seal, then repeat the action for the other side and that’s it!

Details

The McAlpine MZ4 90° Elbow provides a professional-grade solution for tight-angle drainage connections. This heavy-duty fitting utilizes the famous Multifit connection, which seamlessly joins to 50mm, 52mm, and 55mm waste pipes. The universal internal seal accepts multiple materials, including plastic, copper, and lead. Its sharp 90-degree turn allows for efficient pipe routing in confined spaces beneath urinals, showers, or commercial sinks. Consequently, this genuine McAlpine component creates a permanent, watertight joint that handles high-volume drainage with ease.

Creating a sharp turn in a large-diameter waste line often uncovers a frustrating space constraint. Specifically, standard solvent-weld fittings require perfectly clean, dry conditions and offer zero room for error once the glue sets. If your alignment is off by even a few millimeters, the entire joint becomes useless. Furthermore, older installations often feature non-standard pipe sizes that make finding a matching rigid elbow nearly impossible. However, the McAlpine MZ4 90° Elbow solves these issues. The Multifit compression system allows you to adjust the pipe position during installation for a perfect fit every time. Because it grips sizes ranging from 50mm to 55mm, you eliminate the need for multiple adaptors or specialized tools. Therefore, you achieve a professional, leak-free installation in the most restricted areas with a single, reliable fitting.

Brand:

• McAlpine

MPN:

• MZ4