40mm-43mm Multifit Straight Trap Extender Connector (1.5″)

40mm-43mm Multifit Straight Trap Extender Connector (1.5″)

Features

This 40mm to 43mm multifit straight trap extender securely bridges the gap between bath, shower, or kitchen sink traps and misaligned waste pipes. Featuring a 115mm cut-to-length body with a universal compression outlet, it provides a fast, tool-free watertight connection.

• Dedicated 40mm Trap Compatibility: Specifically tailored for 40mm (1.5″) drainage systems found on baths, shower trays, and kitchen sinks.
• Cut-to-Length Flexibility: Measures 115mm overall in length and can be easily trimmed down on-site with a hacksaw if a shorter reach is needed.
• Multifit Universal Compatibility: Engineered to bridge pipes measuring 40mm to 43mm in outside diameter across plastic, copper, and lead.
• Secure Compression End: Features a reliable hand-tightened compression connection that secures instantly without messy glue or solvents.
• Durable Polypropylene Build: Constructed from high-grade polypropylene to withstand daily hot water discharge and household chemicals.

Technical

• Brand: VIVA
• MPN: W40L
• Product Type: Straight Plain End Bath, Shower & Kitchen Sink Trap Extender Connector
• Pipe Size Compatibility: 40mm to 43mm Outside Diameter (Standard 1.5″ Waste)
• Overall Length: 115mm (Cut-to-Size Capable)
• Material Compatibility: Plastic Push-Fit, Solvent Weld, Copper, and Lead Pipes
• Connection Type: Plain Spigot Trap Inlet x Compression Outlet
• Material: High-Quality Polypropylene
• Application: Bridging Gaps and Extending Straight 1.5″ Waste Runs for Baths, Showers, and Kitchen Sinks

Details

When installing a bath, shower, or kitchen sink trap, misaligned waste pipes can halt a plumbing project and cause joint stress. This 40mm to 43mm multifit straight trap extender solves the issue with an adjustable 115mm body that slides directly into the trap and secures with a reliable compression fit for a watertight connection.

Instructions

1. Simply slide the white nut over the pipe first along with the nylon washer, before the pointed black rubber washer
2. Make sure that the black rubber washer is pointing the thin end towards the white fitting you have yet to put on and slide the rubber on an inch or so
3. Push the rest of the fitting on so that the rubber joins up with the plastic fitting, you may then try and push the fitting with the rubber further down the pipe if need be
4. Finally bring the nut back and screw onto the rest of the fitting, compressing the pointed washer against the plastic to make a seal, then repeat the action for the other side and that’s it!

Discover

Explore Our Full Range of 40mm Compression Fittings – CLICK HERE